Speco Technologies HTSD37X Manual de usuario descargar pdf (Pagina 11)

37X Speed Dome Camera 11/50

DIP Switch Setup

Before installing the camera, set up the DIP switch to configure the camera ID and the

communication protocol.

 Camera ID Setup

12345678

z ID numbers of cameras are set up with binary numbers.

See the examples shown below.

Pin 1 2 3 4 5 6 7 8

Binary Value 1 2 4 8 16 32 64 128

ex) ID=5 on off on off off off off off

ex) ID=10 off on off on off off off off

z The camera ID range is “1~255”. Camera ID must not be

“0”!

z The factory default of the camera ID is “1”.

z Match the camera ID with the Cam ID setting of your DVR

or Controller to control the camera.

z If you are connecting a single camera to a controller,

terminate the camera. When connecting more than one

camera to a single controller, terminate the last camera on

the communication line. The last camera means the camera

farthest in cable length from the controller.

z Note that the total length of the communication cable

between a controller and the camera(s) on the same

communication line must be less than 1.2Km.

INSTALLATION 2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Sin comentarios

Speco Technologies HTSD37X Manual de usuario Pagina 11